ESU H0 - 52613 - Attachments - LokPilot DCC V3.0 with 6-pin plug

Description
ESU H0 - 52613 - Attachments - LokPilot DCC V3.0 with 6-pin plug
DC - Direct current - Mint - In original box

ESU H0 - 52613 - Accessories - LokPilot DCC V3.0 with 6-pol plug

The LokPilot V 3.0 DCC controls DCC with 14, 28 and 128 speed increments. The decoder automatically recognizes the number of driving steps. Lenz® LG100 or ROCO braking distances are supported in the same way as Zimos HLU commands or brakes in the DC section with reverse polarity. You can use short (1-127) or four-digit addresses or assign a traction address. It automatically switches between operating modes during operation. RailCom® ensures that the decoder can be read on the main track and the decoder can send its address. In combination with an ECoS control centre and the ECoSDetector feedback module, unprecedented playing possibilities will emerge in the future ​​...

motor control
The minimum and maximum speed of the LokPilot V 3.0 DCC can be set via three points or via a speed table with 28 inputs. The table is effective for 14, 28 and 128 speed steps, which is not self-evident for other digital decoders. Thanks to the unique mass simulation of ESU, even with only 14 speed steps no abrupt transitions are visible.

The fourth-generation load control operates at a clock speed of up to 32 kHz and provides an extremely quiet, silent operation of the engine, especially in engines with a clock anchor. The load control can be easily adjusted to different engine and gearbox combinations.

With Dynamic Drive Control (DDC) you limit the impact of the load control and you can fine tune in the drive and the switching area, while on the (fast) route the locomotive prototypically runs slower uphill.

analogue control
With the LokPilot V3.0 DCC you can not only set the start and maximum speed of your locomotive in analogue mode and determine which functions must be active: even the load control is active! Finally your locomotives crawl into analog mode as slowly as you would expect from digital systems.

Photos are part of the description
Locomotives have a one-month warranty after purchase.

If found to be defective within 1 month, they can be returned free of charge within the Netherlands.
All packages are shipped via registered and insured mail.

Lot details
No. of items
1
Type
Attachments
Brand
ESU
Scale
H0
Catalogue Number
52613
Power supply
DC - Direct current
Condition
Mint
Packaging
In original box
Additional information
LokPilot DCC V3.0 with 6-pin plug
Not registered yet?
By creating your free Catawiki account, you’ll be able to bid on any of our 50,000 special objects up for auction every week.
or Sign in