ESU H0 - 31030 - Electric locomotive - BR 151, engineering edition with full sound - DB Company Number: 151 074 Tested and working, only 1 pantograph does not work. Era IV. Livery: Chromium oxide green. DC/AC; suitable for both 2-and 3-rail systems. Analogue and Digital modes can be used however in analogue mode only with limited functions. Suitable for both DCC and Motorola protocols. LokSound decoder with 22 functions*. (RailComPlus compatible) Metal housing. Metal chassis. Detailing in brass and plastic are affixed separately later steps in brass steel springs in the bogies Sprung buffers Short couplings in NEM 362 shaft with scissor conductors 5-pin ESU high-performance motor. electronically balanced double flywheel 4 axles Cardan drive with worm gear transmission 4 traction tyres. 2 wheel sets without traction tyres are included as an accessory 2 pantographs operated from the central ; lifting and lowering by servos (1 servo is defective) Power Pack energy buffer. shunting lights front signals in warm white LEDs Front- and end-signal lighting alternate depending on changes in the direction of travel. Lighting can be switched off on the side with the coupling Cabin and dash board lights (direction dependent) two Speakers: Bow-sensors Points set sensors. It has a weight of approx. 600 grams. bag with spare parts Overview of the digital functions, depending on your central: F0 - Direction dependent light alternating. F1 - Running sounds (On and Off switch). F2 - Locomotive whistle. F3 - Pantograph up/down. F4 - Control for cabin lighting depending on direction of travel. F5 - Cabin lighting 1 disabled. F6 - Cabin lighting 2 disabled. F7 Control for dashboard lighting depending on direction of travel. F8 - Lighting in shunting mode. F9 - Engine compartment lighting. F10 - Air compressor. F 11 - Station Announcements. F12 - Curve and Points set sensor disabled. F13 - Sounds of coupling. F14 - Oil cooler fan. F15 - Venting compressed air. F16 - Conductor’s whistle. F17 - Engines cooling fan. F18 - Warning whistle. F19 - Fan for braking resistors. F20 - Sanding on the tracks. F21 - Shunting mode. Photos are part of the description Locomotives have a one-month warranty after purchase. If found to be defective within 1 month, they can be returned free of charge within the Netherlands. All packages will be shipped via registered and insured mail.