Beautiful refurbished original Micro. A stereo record player that supports 4 ch. A four pole outer rotor motor equipped with a die-cast radiator is used as the drive system, and a 30 cm aluminum die-cast turntable is driven by a belt drive system. Equipped with an arm rest function linked to the power switch. Equipped with a spring type inside four scan seller. Aluminum hairline finish is used for the motor board. In addition, shock-absorbing rubber legs are used to suppress howling. A low-capacity output code is adopted to support 4 ch. The cartridge is equipped with M-2100/6. SPECS: Drive system: Belt drive system Motor 4-pole hysteresis synchronous outer rotor motor Number of revolutions 33 1/3, 45 rpm Turntable 30 cm aluminum die-cast, 1 kg Uneven rotation Not more than 0.08% Signal-to-noise ratio 48 dB or more Tone Arm Section Type Static balance type (Variable type corresponding to inside force needle pressure) Total Length 295mm Effective length 222mm Overhang 13mm Offset angle 21 ゜ Maximum tracking error 1.5 degrees or less Applicable Cartridge Dead Weight 4g ~ 9g Needle pressure variable range 0 ~ 5g (1 Rotation) Inside for Scan Seller Variable Range 0 to 330 mg Cartridge Section Type MM Type Cartridge (M-2100/6) Frequency characteristic range 10 Hz to 28 kHz Output balance ± 0.5 dB Channel separation 30dB(1kHz) Output voltage 6 mv (1 khz, 3.54cm/s) Load resistance 50k Ω ~ 100k Ω Optimum needle pressure 2g Needle tip 0.6 mil, natural diamond Compliance 23x10-6cm/dyne Exchange needle V-2100/6 (V-2100/5, V-2100/e also possible) Power consumption 14W External dimensions Width 448x Height 159x Depth 340 mm Weight 6.9kg New belt clear dustcover Motor oiled Armlift refurbished and works smoothly again. Bad capacitor replaced. Very nice sounding original card-ridge. With original 45 rpm adapter Carefully shipped on transport mode.