McIntosh - MA6500 Amplificador integrado de estado sólido

Vendo integrado McIntosh
MA6500, 200w a 4 ohm y 120w a 8 ohm por canal, entrada phono MM, no creo que hagan falta más explicaciones para un integrado de gran renombre unanimemente apreciado por diversas figuras destacadas de la audiofilia italiana, definido por el que en paz descanse Bebo Moroni como quizá el mejor integrado McIntosh. Incluye manual y mando a distancia (nunca usado), sin packaging. Condiciones como nuevo.
Specifications
Power Output
Minimum sine wave continuous average power output per
channel, all channels operating is:
200 watts into 4 ohm load
120 watts into 8 ohm load
Rated Power Band
20Hz a 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% para cargas de 4 u 8 ohm
Dynamic Headroom
2.4dB
Frequency Response
+0, -0.5dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
Phono, 2.5mV for 2.5V rated output (0.5mV IHF)
High Level, 250mV for 2.5V rated output (50mV IHF)
Power Amplifier Input, 2.5V for rated output
Signal To Noise Ratio (A Weighted)
90dB (84dB IHF) below 10mV input, Phono Input
100dB (90dB IHF) below rated output, High Level
110dB below rated output, Power Amplifier
Intermodulation Distortion
Maximum Intermodulation Distortion if instantaneous peak output per channel does not exceed
twice the rated output, for any combination of frequencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 4 or 8 ohm loads
Input Impedance
Phono, 47K ohms, 65pF
High Level, 22K ohms
Maximum Input Signal
Phono, 90mV
High Level, 8V
18
Specifications
Preamplifier Maximum Voltage Output
Phono, 8V at tape output
High Level, 8V at tape output
Main Out, 8V at preamp output
Voltage Gain
High Level to Tape: 0dB
High Level to Main: 20dB
Damping Factor
120 a 4 ohms
230 a 8 ohms
Power Requirements
100 Volts, 50/60Hz at 7.4 amps
110 Volts, 50/60Hz at 6.2 amps
120 Volts, 50/60Hz at 6.2 amps
220 Volts, 50/60Hz at 3.1 amps
230 Volts, 50/60Hz at 3.1 amps
240 Volts, 50/60Hz at 3.1 amps
Nota: Consulta en la parte trasera del MA6500 para la tensión correcta.
Dimensiones Generales
Frente: 17-1/2 pulgadas (44.45 cm) de ancho, 7-1/8 pulgadas (18.10 cm) de alto. Profundidad detrás de la placa frontal de montaje es de 16-1/2 pulgadas (41.91 cm). Se requiere espacio libre delante del Frontal para los mandos de 1 pulgada (2.54 cm).
Peso
en caja de envío
74.5 libras (33.8 kg) neto, 92.5 libras (41.7 kg) en el embarque