NAD - C350 Amplificateur intégré à semi-conducteurs

NAD C350
Stereo Integrated Amplifier (2000-01)

The family resemblance of this amp to older NAD amplifiers is obvious. There have been developments in areas like styling, but the principal changes externally are in matters of detailing. Internally, crude construction standards and an excess of point-to-point wiring lies in the past, and frame transformers have been replaced by toroids, which produce lower noise, a reduced hum field and less interference with adjacent circuits.
The C350 is a discrete design throughout with bipolar output devices, and like other recent NAD amplifiers, the C350 employs a proprietary Impedance Sensing Circuit, which examines the load and optimises itself accordingly. This has a side effect that the amplifier develops an identical 60 watts into both 8 and 4 Ohms. The C350 has impressive dynamic reserves, with a claimed 135, 190 and 240 watts dynamic (peak) power into 8,4 and 2 Ohms respectively, and a peak current capability of 55 amps. The C350's official continuous power rating is 60 watts/channel, though some NAD literature describes it as a 50 watter, and it is equipped with seven relay switched line level inputs, two of which are tape circuits with a dubbing link between them. Discreet LEDs indicate power status, and the selected input.
Standard NAD features, like bypassable tone controls, and Soft Clipping (a form of output limiting designed for high volume use at parties where sound quality is not an issue) have been retained, and so is a removable link between the pre-and power amp. This model even includes a second preamplifier output, which in combination with the first one can be used with gain matched power amplifiers for bi- or tri-amping. The C350 also has potential in multi-room systems thanks to a 12V trigger output which can be used to switch external components with trigger inputs from standby to on, and vice-versa.

Optically and technically in well condition. With remote

To deliver this product properly, it is packed in very strong boxes, thereby encased in bubble wrap. In addition to the strong packaging, the box is labeled as fragile, using orange "fragile" tape. In case of further packing requirements please message after purchase.

Specifications
Power output: 60 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.03%

Damping factor: 150

Input sensitivity: 325mV (line)

Signal to noise ratio: 96dB (line)

Speaker load impedance: 4Ω (minimum)

Dimensions: 435 x 100 x 290mm

Weight: 7kg