N.º 98682890

Vendido
Rotel - RX-202 Receptor estéreo de estado sólido
Puja final
€ 85
Hace 8 semanas

Rotel - RX-202 Receptor estéreo de estado sólido

Vintage Rotel receiver. Good reception with short antenna. Also FM stereo. Works good for phono and aux- tape. New green leds placed. Power type and voltage Alternating Current supply (AC) / 100; 120; 220; 240 Volt Loudspeaker - This model requires external speaker(s). Power out 40 W (undistorted) Material Wooden case Model: Stereo Receiver RX-202 - Roland Electronics Co. Ltd., Shape Book-shelf unit. Dimensions (WHD) 475 x 115 x 250 mm / 18.7 x 4.5 x 9.8 inch Notes An AM/FM stereo hi-fi receiver with a stereo tuner covering MW and FM and an integrated amplifier with output power of 2 x 20 watts RMS into 8 ohms. Housed in a walnut veneer cabinet with a black or silver front. Tuning Meter, Rotary Bass and Treble tone controls, push button switches for Speakers 1 and 2, High Filter, Loudness and Tape Monitor, terminals for FM and AM antennae, RCA phono sockets for Tape/Aux input, RCA phono and DIN sockets for phono cartridge input (Magnetic and Ceramic) and for Tape Monitor Input/Output, terminals for two pairs of loudspeakers, a switch for simulated 4 channel, jack for headphones and a switched AC outlet. Specification Amplifier Section Continuous Power Output 20 watts per channel min. RMS both channels driven into 8Ω from 40 to 20,000Hz with no more than 1% Total Harmonic Distortion IM Distortion less than 0.2% at rated output Frequency Response 10 - 70,000 Hz ±3dB at 1 W/ch Damping Factor 30 (8Ω, 1kHz) Input Sensitivity/Impedance TAPE MONITOR 150mV/45kΩ AUX 150mV/45kΩ PHONO 2.5mV/45kΩ Tape Output (RCA) 300 m V/3.3kΩ (DIN) 100 mV/90kΩ Phono Equalization RIAA STD. ±1.0dB Crosstalk 50dB Hum and Noise (S/N) (continuous power output) PHONO 70dB TAPE 85dB Residual 1.0mV Speaker Impedance 4 to 16Ω, SPKR 1 or 2 8 to 16Ω, SPKR 1 + 2 FM Tuner Section Frequency Range 88 - 108 MHz Sensitivity (IHF) 2.5 µV (26dB), 5 µV Signal-to-Noise Ratio 70dB Harmonic Distortion 0.2% ( mono) 0.5% (stereo) Selectivity 45dB (alternate channel) Capture Ratio 3dB Stereo Separation 40dB at 1kHz, 30dB at 100 Hz IF Rejection 70dB Image Rejection 55dB Spurious Response Rejection 70dB AM Tuner Section Frequency Range 525 to 1650 kHz Sensitivity 200 µV/m Selectivity 26dB IF Rejection 70dB Image Rejection 45dB Versions/Power Requirements 120V AC 60Hz 220V or 240V AC 50/60 Hz 100/120/220/240V AC 50/60 Hz Power Consumption: 130W See also the similar earlier Rotel RX-202 Stereo Receiver. Net weight (2.2 lb = 1 kg) Carefully shipped

N.º 98682890

Vendido
Rotel - RX-202 Receptor estéreo de estado sólido

Rotel - RX-202 Receptor estéreo de estado sólido

Vintage Rotel receiver.
Good reception with short antenna. Also FM stereo.

Works good for phono and aux- tape.
New green leds placed.

Power type and voltage
Alternating Current supply (AC) / 100; 120; 220; 240 Volt
Loudspeaker
- This model requires external speaker(s).
Power out
40 W (undistorted)
Material
Wooden case

Model: Stereo Receiver RX-202
- Roland Electronics Co. Ltd.,
Shape
Book-shelf unit.
Dimensions (WHD)
475 x 115 x 250 mm / 18.7 x 4.5 x 9.8 inch
Notes
An AM/FM stereo hi-fi receiver with a stereo tuner covering MW and FM and an integrated amplifier with output power of 2 x 20 watts RMS into 8 ohms. Housed in a walnut veneer cabinet with a black or silver front. Tuning Meter, Rotary Bass and Treble tone controls, push button switches for Speakers 1 and 2, High Filter, Loudness and Tape Monitor, terminals for FM and AM antennae, RCA phono sockets for Tape/Aux input, RCA phono and DIN sockets for phono cartridge input (Magnetic and Ceramic) and for Tape Monitor Input/Output, terminals for two pairs of loudspeakers, a switch for simulated 4 channel, jack for headphones and a switched AC outlet.

Specification
Amplifier Section
Continuous Power Output 20 watts per channel min. RMS
both channels driven into 8Ω
from 40 to 20,000Hz with
no more than 1% Total Harmonic Distortion
IM Distortion less than 0.2% at rated output
Frequency Response 10 - 70,000 Hz ±3dB at 1 W/ch
Damping Factor 30 (8Ω, 1kHz)
Input Sensitivity/Impedance TAPE MONITOR 150mV/45kΩ
AUX 150mV/45kΩ
PHONO 2.5mV/45kΩ
Tape Output (RCA) 300 m V/3.3kΩ
(DIN) 100 mV/90kΩ
Phono Equalization RIAA STD. ±1.0dB
Crosstalk 50dB
Hum and Noise (S/N)
(continuous power output) PHONO 70dB
TAPE 85dB
Residual 1.0mV
Speaker Impedance 4 to 16Ω, SPKR 1 or 2
8 to 16Ω, SPKR 1 + 2
FM Tuner Section
Frequency Range 88 - 108 MHz
Sensitivity (IHF) 2.5 µV (26dB), 5 µV
Signal-to-Noise Ratio 70dB
Harmonic Distortion 0.2% ( mono) 0.5% (stereo)
Selectivity 45dB (alternate channel)
Capture Ratio 3dB
Stereo Separation 40dB at 1kHz, 30dB at 100 Hz
IF Rejection 70dB
Image Rejection 55dB
Spurious Response Rejection 70dB
AM Tuner Section
Frequency Range 525 to 1650 kHz
Sensitivity 200 µV/m
Selectivity 26dB
IF Rejection 70dB
Image Rejection 45dB
Versions/Power Requirements
120V AC 60Hz
220V or 240V AC 50/60 Hz
100/120/220/240V AC 50/60 Hz

Power Consumption: 130W

See also the similar earlier Rotel RX-202 Stereo Receiver.

Net weight (2.2 lb = 1 kg)

Carefully shipped

Puja final
€ 85
Ariel Cabello
Experto
Estimación  € 150 - € 200

Objetos similares

Para ti en

Equipo de sonido

Configura una alerta de búsqueda
Configura una alerta de búsqueda para recibir notificaciones cuando haya nuevas coincidencias disponibles.

Este objeto apareció en

                                        
                                                                                                    
                    
                                        
                                                                                                    
                    
                                        
                                                                                                    
                    
                                        
                                                                                                    
                    

Cómo comprar en Catawiki

Más información sobre nuestra Protección del Comprador

      1. Descubre algo especial

      Explora miles de objetos especiales seleccionados por expertos. Mira las fotos, los detalles y el valor estimado de cada objeto especial. 

      2. Haz la puja más alta

      Encuentra algo especial y haz la puja más alta. Puedes seguir la subasta hasta el final o dejar que nuestro sistema puje por ti. Todo lo que tienes que hacer es fijar una puja máxima con la cantidad máxima que quieres pagar. 

      3. Paga de manera segura

      Paga tu objeto especial y nosotros retendremos el pago hasta que el objeto te llegue en perfecto estado. Utilizamos un sistema de pago de confianza para gestionar las transacciones. 

¿Tienes algo similar para vender?

Tanto si las subastas online son algo nuevo para ti como si vendes profesionalmente, podemos ayudarte a ganar más por tus objetos especiales.

Vender objeto